|
Fish Casting Boat Headquarters |
![]() |
![]() SR-1 has US Patent No.7055280 issued on 6/6/2006 Chainsawsculptors.com 243 North Hill Road Iron River, Michigan 49935 906-265-9599 |
|
"Your Fishing is Our Business" |
|
Step 1 - Fully
charge the battery *Low battery power could affect SR-1 control range. Step 2 - Install battery into controller and caster before turning on either device. Step 3 - After turning on both controller and caster switch while holding down release button, attach fishing line with caster via swivel loop. Step 4 - Hook your baits on and drop them into water behind the caster. Step 5 - Set your caster in water - now you are in control of sending your lures up to 500 feet away (Depending on the length of your fishing line) *To avoid line tangle with propellers, do not put your SR-1 in reverse while bait is onboard. **To avoid damage your SR-1, do not drop your caster to the ground. ***To avoid destroying release system, do not grab its tail section, be sure to hold the Precision Caster on its main body. Step 6 - Stop the caster at the desire fishing location then release your lures by pushing down the release button in your controller. Step 7 - Control your caster back to your casting position and enjoy fun fishing. Step 8 - Repeat step 1-7 for the second and/or third fishing pole so you can fish many different spots at the same time. * This system works well with any fishing pole as long as it has a swivel that can connect to our Precision Caster SR-1, you also can purchase Fishing Rod Adapter to mount Controller on your rod. * To serve you right, we inspect and install every SR-1 before delivery, battery is included.
To increase the range of
Precision Caster SR-1, please attach a piece of aluminum foil over
antenna. It can boost the range by 50%. The total range is over 500
feet.
You only need to
choose the right bait for the fish; Precision Caster does the rest. It
is easy to use and fun! You only need to choose the right bait for the fish; Precision Caster does the rest. It is easy to use and fun! Tips:
Baiting bowl float behind SR-1 Baiting bowl mounting on SR-1 Fish Finder installed
. Mr. Albert McBee's Rigging method - I cut the corner from the packaging of the Hummingbird RF30 and super glued it to the starboard lower wing of the SR-1. The bait and rigging in the cup stays put until the release button is pressed and the line is tugged. (see picture) I can use a Carolina rigged hook (slip-sinker) by placing the sinker in the cup and running the main line from the rod above the servo ram which is pinned through the swivel eye. The terminal rigging is tied through the opposite end of the swivel from the main line from the rod. A three-way swivel can be used with the terminal tackle tied to one eye, the sinker tied to a second eye and the main line tied to the third eye. The sinker can be secured in the servo clip while the terminal tackle trails behind the boat. |
|
Home
- Precision Casters
-
Accessories
- Battery Care -
Fish Finders
-
Fishing Gallery Fishing Links - Instructions |
|
Chainsawsculptors.com®(chainsawsculptors.com) Copyright ©2003 - 2008 All rights Reserved |
Web Design by:
chainsawsculptors.com &
Annhummingbird Powered by ixwebhosting |